1983 Toyota Land Cruiser "hard starting" Questions

Ad

Question about Toyota Land Cruiser

1 Answer

it is hard to start i have changed the glow plugs but still hard to start some times ARE YOU WAITING UNTIL THE GLOW PLUG WARNING LIGHT GOES OUT DIESEL ENGINES REQUIRE THE GLOW PLUG TO WARM BEFORE ...

Ad

Question about Toyota Land Cruiser

1 Answer

1hz hard to start when cold My 1hz land cruiser won't start when its cold glow plug been replace but still can't start after push start than can start easily

Ad

Question about Toyota Land Cruiser

1 Answer

landcruiser colorado vx auto diesel power loss will hardly move off hardly any response from accelarator will eventually get to about 70mph orange engine warning light on turbo ok I would start out by

Question about Toyota Land Cruiser

1 Answer

100 series land cruiser hard to start when hot,GOOD START WHEN COLD,RESTART AFTER 10 MINUTES,DOES START BUT IF LEFT FOR 2 MINUTES,IT WILL NOT START UNTIL NEXT 10 MINUTES. did you find out what was ...

...ON OCCASIONS A SLIGHT UNEVEN IDLE BUT NOT HARD STARTING maaayyyyyybe, but you should check your fuel pressure first an take a look at your fuel pressure regulator some times thats the problem good ...

Question about Toyota Land Cruiser

1 Answer

hard down shift 1999 Land Cruiser with 189k miles. Original owner. Very well maintained. Transmission is down shifting a tad hard when coming to a stop. Feeling some drive train "slap". Maybe a result

Question about Toyota Land Cruiser

1 Answer

1988 toyota hj75 land cruiser when my motor is at running temp it is very hard to start just cranks and cranks over then finally starts Repelce fuel filter, check is there any fuel leak, also check ...

...idle at 350 to 400 RPM. A few trips later and hard starting, it wont run now Test for a bad crank position sensor. An automatic idle control valve most likely is gummed up and needs to be cleaned

...hard starting may be the glow plugs, which pre heat the engine, but that's doubtful as it starts after an hour or so....The most likely cause , is a worn head and rotor....If you need to fit a ...

i can not get my new ignition cyclinder lock in I would like to know if someone can help me put my ignition cyclinder lock in my 1997 toyota prado...thank you I just change my prado ignition ...

Not finding what you are looking for?
Cars & Trucks Logo

88 questions posted

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...