2007 Toyota Tacoma "hitch pin" Questions

...hitch put on. It has a 4 pin flat connector that is converted to 7 pin to connect to my Coleman camper. When I connected it, all the lights worked fine. Later when I was towing, I notice the trailer ...

...pin the culpret? The only thing not done factory on the truck is I had a receiver hitch and towing lights harness installed about 3 months ago. I inspected it and didn't see any bare wires. Only ...

...hitch and ball little give is normal There is generally a little slop in hitches. Even though the pin or bolt is tight - there is usually a little extra room in the receiver - which is why you end up ...

...hitch shop and plugged it in the factory wires under the bumper. I am getting no power to any of the pins. Whats going on here? u must install the fuses for the system in he underhood heavy duty fuse ...

...wiring harness for a 2015 Nissan Pathfinder. I have installed the hitch and the rear trailer wiring but not the 12 pin wiring harness. Thanks I KNOW OF 4 WIRE HITCH CONNECTION, WHY SO MANY

...pin connector at trailer hitch, if your truck came from the factory with a trailer hitch. If you are adding the hitch and do not have the four wire harness, the under hood wires from your brake ...

...located? To reduce my hitch sleeve fron 2.5 to 2" supposed to be in the receiver port on the rear towing hitch sounds like someone removed the receiver and never put the pin back in so it fell ...

pin to the hitch light or from hitch light to ground. l would also check switch for brakes. This you should find at or near top of peddle (brake ) behind it.Could be broken or connection,take a lot of

2002 ford f-150 7-pin hitch wiring problem. There is no power to the accessory pin but everything else works fine with the other trailer connections. check fuse allso ford trailor package relay #2

...tail lights on my 2011 Ford Escape won't come on. Brake and signal lights working. Have a trailer hitch and wiring connected. Has autoturn on but it is working and lights won't come on using manual ...