1985 Toyota Pickup "2 crank timing marks" Questions

...crank 2 complete revolutions of crank pulley-that is 4 rotations of cam(s).all marks should be aligned(sprockets and marks)not always paint marks on belt though.if not aligned patience needed more ...

...the timing gear no --- the revolutions of the cam shaft is set to half the numbers of the crank shaft so that means that you will have to turn the crank 2 full turns to get the links to line up ...

...Isuzu Motor Co. yes it could be due to the distributor. sounds like your cam to crank timing is correct try turning the distributor a tooth or 2 in different direction and see if u get positive ...

...2) TIMING MARK ON CRANKSHAFT, MAKE SURE TS EXACT ON "0". IF THOSE TWO DONT SHOW ON THE EXACT MARK THE TIMING IF OFF.!!! THEN TAKE IT APART AND MAKE SURE THOSE TOW ARE ON THE DOT. -- TDC AND CRANK ...

crank pulley and 3 on the cam pulley along with the numbers 1 2 3 . My unit has a timing chain not a belt what is the proper alignment of these marks? u need a repair manual-find one at fixya or go to

timing light 101?) checks? 2: compression wrong, timed cam wrong. when we do cam work (disturbed) we check compression first. if DOHC engines, leak down is down by hand. that way we know for a fact we

...2 of them 1342 and 1432, You'll need to check the timing and the firing order. Bring the engine to top dead center, use the mark on the front pulley. take spark plug# 1 out.Is the piston up? Top ...

...2 sides of connector, base and bolt head) before replacement. Do not use metal to clean, only things like scotch bright pads or you could scratch the surfaces causing a leak that would result in an ...

...crank And must i use the screw driver technique to make sure piston nbr one is on its highest point Because the car starts well and drive well but its like i have a lost in power Can someone please ...

...2 motor. there is a small mark on the cam pully that must point strait down to the mark on the crank shaft timing pully. the mark on the crank pully is a bit hard to see but it is a low spot on the ...