...turn signal / cruise control was replaced and the plug for the cruise control is hanging down under the dash. I would like to plug it back in. Remove the covers below the steering column. Locate the ...
Question about Cars & Trucks
...turn signal lever. The cruise control function control switches includes the ON/OFF, SET/COAST, R/A (resume/accelerate). The switch assembly provides driver control of the cruise control system. The ...
...remove it just push turn and pull the only thing is that if the car has cruise control you got to cut the wire... and to install it your car push in and turn wiper will work signals but no cruise ...
Question about Cars & Trucks
...turn signal and hazard warning flashers. Removal Procedure Remove the center air deflector. Refer to Instrument Panel Center Air Outlet Deflector Replacement . Squeeze the retainer on the backside of ...
...signal circuit. The vehicle speed stored in the memory of the PCM will be erased when the cruise control On/Off button is turned OFF, or the ignition switch is turned OFF. The Cruise Control System ...
...a short to ground.The cruise control wont cause the turn signals to fail cause they are in a seperate electrical circuit.Remove the bezel from under the steering colume nd look for any chafed
Question about Toyota Sequoia
...signal and cruise control quit working when the turn signals work, cruise control does not, when the turn signals do not work, cruise control does work. everyone i talk to about it wants me to buy a ...
...turn signal) switch. It is common for these switches to short internally. Partial disassembly of the steering column is required to replace it. The airbag stsyem must be disabled, then the airbag ...
...turn on a signal-either left or right. The 2004 Sequoia has 145,000 miles on it and has been a champ-this problem just suddenly appeared one day. I'm on cruise control heading down highway, come upon ...
457 questions posted
Usually answered in minutes!
278 Questions
292 Questions
255 Questions
151 Questions
76 Questions