2004 Toyota Corolla "remove alternator 6 cylinder" Questions

...alternator air inlet duct. Fig. Remove the 2 nuts, the bolt and the alternator air inlet duct-2.3L engine Disconnect the 4 ignition coil-on-plug electrical connectors. NOTE When removing the ignition ...

Remove the two uppermost 15mm-head bolts from the top of the a/c , alternator bracket where it attaches to the head and unplug the single wire temperature sending unit 10. Remove the upper half of the

...taken the alternator to Auto Zone and they say it's working but it's for a 4 cylinder and my car is a 6 cylinder. Does this make any sense? you need to check voltages and grounds to the

...REMOVE THE DRIVE BELT.THE ALTERNATOR AND THE AC COMPRESSOR WITH OUT DISCONNECTING THE REFRIGERANT LINES.THEN REMOVE TENSIONER CENTER BOLT. THE 6 CYLINDER ENGINE YOU HAVE TO REMOVE DRIVE BELT.RAISE ...

...remove the bracket the alternator was mounted to... after removing the bracket the alternator should have just enough room to be wiggled out... Well, I took a slightly different tack. I removed the ...

...remove alternator i need to replace the alternator,how do you remove it.   Park vehicle on level ground. 2. Remove battery from vehicle. 3. Remove air cleaner outlet hose, engine under cover ( ...

...models the belts are just held on by various tensors either attached to their accessories (alternator, Powersteering) or via a pulley (AC, water) Release the tension, remove and replace the

how do i change the alternator on a 6 cylinder 05 chrysler sebring?? YOU NEED A HAYNES REPAIR MANUAL.IT WILL SHOW YOU STEP BY STEP HOW TO REMOVE THE ALTERNATOR.

where is the thermostat located? Assuming you have the 6 cylinder, the thermostat is on the drivers side of the engine just behind the alternator. Here is a view with alternator removed.

remove alternator. 5. Replace alternator with the new one and put bolts back on. 6. Reconnect any plugs or wires that were disconnected to the right place. 7. Loosen tensoioner pulley and replace belt