2003 Toyota Camry "97 2 fuel pressure" Questions

...97 Camry is located on the firewall, on the driver side of the engine compartment, right above the transmission. This is not easy to change. Suggest that the engine to be cold when attempting this to ...

...97' grand am starts and stalls ,it has a 3100 sfi engine and is not showing any codes, any ideas ? I'd go with replacing the fuel filter, especially if it hasn't been replaced. It should be replaced ...

97 Blazer The fuel PUmp RELAY is located in Right side of dash Behind the glove BOX. You can identicate for the colour of the wires. 1- Black/white 2- Dark green/white 3- Gray 4- Orange 5- Red. NOTE..

...pressure specs for 97 Chevy Silverado 350 2 wheel drive Base fuel pressure at idle for a MPFI engine is around 40-45 psi. It if were a vortec engine like the 4.3 V6 the pressure would be around

...2 get inspection I have a 97 plymouth voyager. I have 2 codes being read. P0300 and P0304..random misfire and misfire in cylinder 4. We have replaced spark plugs,wire set,dis. cap and rotor. Also ran ...

...2 yrs ago,someone mentioned the (ECT) Its your fuel pump.I had the same plomblem not too long ago.I was spraying either in to start it.I have a 97 chevy truck witch requires 65 psi to start and 55 to ...

...97 chevy tahoe 5 7 problem: If you look at the top of the upper intake manifold plenum with the air intake duct work off you will see 2 shiny fuel tubes that feed into the fuel meter body. The fuel ...

...97 gmc yukon now it stays running but the idle stays high I have attempted to disconnect the battery and ran a fuel treatment no codes show up on code reader. I'm lost any help? With a scanner that ...

...97 you have 2 fuse panels, one in the truck and one under the hood. Also if you are handy with a meter check the wiring of the pump wih the meter from under the truck when the key is on, if you are ...

...97 Achieva starts but dies as soon as ou let off the starter. Even if you hold it, it dies and the starter continues cranking the engine. It won't try again unless you wait a few seconds. Will only ...