2001 Toyota Celica "install rear wheel bears" Questions

...rear hub bearing assembly). Break the lug nuts loose of wheel of the hub bearing you're replacing with the breaking bar and a socket; just loosen-- do not remove them until the wheel is lifted off of ...

...torque the bolts to 88 ft lbs-install the brake caliper and rotor.install the wheel speed sensor if equipped.install the rear wheel.TO BUY THE TOOLS TO DO THE JOB.LOOK UP KENT MOORE TOOLS ON

...or equivalent device. Starting torque should measure 15.9 in lb (1.8 Nm) or less Install brake disc. Mount brake caliper. Install rear wheel speed sensor to carrier. Install rear wheel

...Rear wheel bearing removal-4wd To install: Install or connect the following: Wheel bearing in to the knuckle Snapring Wheel hub into the wheel bearing Wheel hub nut. Torque the nut to 214 ft. lbs. ...

Install rear brake anti-lock sensor indicator . Tighten retaining bolt to 4.5-6.8 Nm (40-60 lb-in). Install rear disc brake caliper and rear disc brake rotor . Install wheels and tires. --------------

...Install or connect the following: Inner wheel bearing Grease seal Hub assembly Lock nut. Adjust the locknut to achieve wheel bearing play of 0.001-0.006 inches (0.025-0.152 mm). Lock nut cover Cotter ...

...Rear brake drum Wheel hub nut Wheel hub Inner wheel bearing race from the hub Snapring Wheel bearing outer race from the knuckle To install: Install or connect the following: Wheel bearing in to the ...

...rear bearing hub, install the brake drum to the hub assembly and install the retaining screws. Install the wheel and tire assembly. Adjust the rear brakes as required. Apply the brakes until a firm ...

...Rear) in Disc Brakes. Install the wheel and the tire. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment. Tighten the wheel nuts to 140 Nm (100 ft. lbs.). Lower the ...

...install rear wheel hub bearing assembly.thanks................................................rgp Easy job ! just rem to get a gear puller for the antilock gear and install same as came off old one ...