cam shaft torques for caps and cover 3.0tdohc Bolts in the center of the cams 28.2 ft/lbs Bolts on the outside of the cams 15.9ft/lbs INSTALLATION 1. Cylinder head cover. 1) Install the cylinder head ...
Question about Toyota Celica
...cam sensor ,disconnected it a couple times and service light disappear,knowing is going bad I drove it 3 days w/o service light on but the 3rd day on my way home,the service light came on again. the ...
...3:43 PMI only have (1) cam cog Check the crank sensor wires I can't comment about your engine as I am not familiar with it but generally the spark would be present regardless of the timing, though it ...
...cam seals too? Thanks Matt 1. Remove the 14mm bolt. 2. Remove the spring holding onto the tensioner 3. Remove the tensioner 4. Installation is the reverse. I install a new tensioner with every timing ...
cam start with first cap on left being #1 then bolt on other side of cap as #2. Cap behind would be #3 to left then #4 bolt next to it. Keep tightening the next 2 caps behind them in same manner, then
Question about Toyota Celica
...installation of my intex webcam model no. IT-305wc send me driver to download thanking you 1. Go to: http://www.intextechnologies.com/webpages/download-driver.aspx 2. Under the "Download Drivers" ...
cam to bind and break 3. If no pre-lube was used during install, cam will also bind and snap before oil can reach it. In any case, I would not use that cylinder head again unless extensive (expensive)
...installation: a. Lefthand side cam chain. b. Righthand side cam chain. c. Oil pump chain. d. Primary chain. 13. Reset righthand cam chain tensioner by pushing back tensioner piston and installing ...
381 questions posted
Usually answered in minutes!
303 Questions
345 Questions
273 Questions
241 Questions
205 Questions