...grinder cut at an angle and almost all the way in get a cold chisel and hit the cut hard and the bearing will crack and be easy to pull off I suggest a small hand held torch to heat the bearing. It ...
...grinder to cut through it or a sawsall..depending on the room to work..which is usually very small..it may require two people for removal as one needs to be inside and one outside..sorry I wasnt much ...
...small hammer to drive the pin up and out from the bottom. It is just stuck in the hole. jeep doors are usualy in there prety tight. try moving the door back and forth at the same time as you are ...
small grinder, cut off the flattened ends that stick through the backing plate. You will have to replace them once you finally get the drum off. Reapeat the procedure mentioned above. You are probably
...small extension and ratchet. Lower the tire as far as it goes. Locate the 15mm bolt that attaches the tire hanger to the frame, undo the bolt, the hanger is then swinging from the back, lift up the ...
...grinder and install the new bracket. You remove the grille to do the install. It is an easy job and shouldn't take more than 30 minutes. Ford has a 7 page set of instructions for this Program, titled ...
small torch and get the rotor hot, it seems that heat will loosen up the rust that has frozen the rotor on to the hub. I just get it really hot and then hit it with a hammer and it works wonders. This
882 questions posted
Usually answered in minutes!
1,828 Questions
1,753 Questions
1,565 Questions
1,303 Questions
1,134 Questions