front driverside tire wobbling and very unstable lug tight Check the wheel hub bearing, jack so the wheel is off the ground, if the wheel can be moved in any direction 360 degrees, then the bearing is
front driver tire wobbling and very unstable lug nuts are tight Is there and kind of squeling or grinding noise when the vehicle is driven? The wheel bearings could have failed and are allowing the ...
...front. So much now that my wife notices it. I checked under the car and found no signs of worn tie rod bushings, motor mounts or other mount rubber parts. I did try to check condition of CV joints by ...
front bearing wheel nut holding axle on? 115 foot pounds and hammer in or crimp the nut after tightening. ^ like shape into slot of axle this locks the axle. for the wheel bearing for rear wheel drive
...noise. Wheel bearing changed,drive shafts ok, seal greased and tight,bolts are all shut tight...what could it be? Did you replace one front bearing or both? It could be the other front wheel
...front wheel bearings keep getting tore up what do i do next have been changing wheel bearings fer three days now never had this issue before but the bearings keep going out Bearing is going out or ...
Question about Chevrolet Cars & Trucks
...tight Hey James, the torque spec on that front axle wheel bearing nut is 177 Ft /lbs. There is a process that you should follow and over or under torque is a leading cause of bearing failure. The ...
...front wheel bearing for your Impala is an integrated wheel hub/bearing/ABS. The whole thing gets replaced. It should look like the one off my Bonneville; Bearing. Remove wheel/tire. Remove brakes. ...
...front wheel bearing I don't think you will be able to adjust the bearing. You may check to make sure that the hub is on tight. Not sure if you change change just the bearing/race OR if you would have ...
Question about Toyota Camry
...Front Brakes 93 97 Ford Ranger 2WD 1AAuto com Replacing Rotors with Tapered Roller Bearings EricTheCarGuy did u clean it real good and pak the new bearing good did you spin it to check before you put ...
2,329 questions posted
Usually answered in minutes!
1,828 Questions
1,753 Questions
1,303 Questions
1,134 Questions
1,141 Questions