1996 Toyota 4Runner "remove engine" Questions

...Remove the cosmetic/acoustic engine cover. Disconnect the accelerator cable and intake air connector. Remove the intake manifold assembly. For additional information, please refer to the following ...

Remove the engine under cover. Remove the alternator. Unbolt the alternator bracket. Disconnect the crankshaft position sensor harness. Remove the bolts securing the sensor and the sensor. Discard the

...timing belt remove intake housinng once you have remove all the above, your freaken engine will look naked, you can see the location of the knock sensor is locate in the engine valley u need a new ...

engine crank. Good Battery. Open circuit relay test good with correct resistance. Any suggestions. Thanks for reading my email and for your help. I think gas is not getting to your fuel rail. Could be

remove engine support brackets. There are many sites, such as youtube that have online instructions of your particular make and model. j Thanks for using FixYa - a 4 THUMBS rating and POSITIVE Comment

...remove engine there is a cover at the bell housing of the gearbox! remove its bolt then access the thin fly wheel! there are bolts that attach it to the torque converter! remove all as you rotate the ...

remove it while the engine is hot as it helps the oil to be removed from the engine almost completely so that there is hardly any old oil in the Engine , after you put new oil in it.Hope this helps...

engine a bit and this should remove any remaining air. also drive front end up on ramps that will give you the highest point for you air to escape There are very few cars these days that need bleeding

...Engine To remove the serpentine belt on the 2UZ-FE engine, position a suitable sized wrench or ratchet and socket over the belt tensioner bolt, rotate the tensioner counterclockwise to release the ...

...a new one £22.77, re-started the engine' oil light still on after 5 seconds, turned of the engine removed the new sender unit re-started the engine found no oil at sender unit point, turned of the ...