1991 Peugeot 405 "handbrake tension" Questions

tension on the handbrake, but to compress the cylinder, you need a 'cylinder wind back tool'. Which is basically like a 'vice' but as you tighten it, it screws the cylinder back in. That's yer problem

...handbrake on 2, loosen drivers side front wheel bolts, 3, crawl under car use 22mm socket and breaker bar to loosen the crankshaft pulley bolt, it'll probably be quite tight, once undone nip it up ...

handbrake does not hold very well.... can you suggest an answer tighten the hand brake tensioner you need to ajust the ajuster the bottom of the braks to where they are slighty tight to the calipar if

handbrake lever no tension Pulled on the handbrake and when it reached normal height full on it banged now its not fully loose but almost no tension and goes nearly vertical does not hold car at all ...

...tension your handbrake and one of them is just behind the acctual handbrake lever which is usually an ashtray or some kind of panel which will just remove and reveal a bolt with two secondary bolts ...

...Handbrake is normally mechanically connected to the brakes by steel cable 1/8 inch thick. At the end of the cables are bolts with adjusting nuts to adjust the handbrakes. These nuts must be adjusted ...

...tension on the handbrake by adjusting the handbrake lever to its lowest position. Depending on your vehicle's setup, you may need to remove the center console to access the handbrake lever assembly. ...

handbrake tension adjust The handbrake adjustment is at the handbrake. Pull off the rubber boot around the hand brake. (it pulls open at the botto of the handle and slips off over it). Next locate the

how do i adjust my saab 9-3 handbrake on the bottom of handbrake shuld be a adjusting nut also halfway down vechicle shuld be a tensioner bolt under carriage

what do you call the piece of handbrake cable that joins front cable at tensioner to back cables as this piece has snapped The forward handbrake cable? Just explain it to the spares place, they will ...