1991 Peugeot 405 "bleed thermostat houseing air" Questions

Ad

...THERMOSTAT AIR BLEED HOLE FACING LEFT SIDE UPWARD ON THE ENGINE.SOME THERMOSTAT HAS TOP STAMPED ON IT.MEANING MUST BE FACING UP.WHEN THERMOSTAT IN PLACE.TAKE NEW THERMOSTAT GASKET.PUT SEALER ON BOTH ...

Ad

bleed valve of the old thermostat while in the housing (bleed valve hole is normally on the top /facing up) Pull out thermostat and gasket. Note that the rubber gasket fits over/around the edge of the

Ad

the side of the housing preferably a rubber mallet or plastic hammer. to free it upTo bleed air leave the expansion tank cap off let the engine run until thermostat opens to fulll operating teperature

...a 1999 Buick century custom V6 3100? Just replaced water pump and would like to know exactly how and where to bleed air from system. Brass air bleed Open the air bleed vent on the thermostat

Question about Peugeot 405

1 Answer

...yes if there is air that needs bleeded out of the system. some cars hav a means to bleed the system near the thermostat housing see alldatadiy.com for info on how to bleed air out of ur specific

Question about Peugeot 405

2 Answers

...thermostat with a new gasket, clean off any old gasket material, reinstall the housing cover and air box, and then fill and bleed the cooling system. Thank you !! http://youtu.be/Q6JbMATEQHw Like ...

Question about Peugeot 405

1 Answer

...on the housing and the engine side. Install new thermostat with new o-ring seal. And reinstall housing. Top off cooling system and bleed any air out of system with bleeder that is ontop of

...Bleed (purge) hose, thermostat housing 12 - 'Y' piece ejector 13 - Expansion tank 14 - Heater rail 15 - Heater unit 16 - Heater feed hose 17 - Intercooler 18 - Air cleaner 19 - Air feed hose 20 - ...

...thermostat with the air bleed valve at the top Install the new thermostat and gasket. Install the thermostat with the jiggle pin facing up. This acts as an air bleed and must be at the top of the ...

AN AIR BUBBLE AT THE THERMOSTAT/HEAT SENSOR. THER IS USUALLY A SMALL PLUG OR BLEED FITTING IN THE AREA OF THE THERMOSTAT HOUSING. WARM ENGINE AND BLEED AIR SEVERAL TIMES AS REQUIRED HOPE IT WORKS !!!!

Not finding what you are looking for?
1991 Peugeot 405 Logo

638 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1990 Peugeot 405
1990 Peugeot 405

103 Questions

2005 Peugeot 405
2005 Peugeot 405

805 Questions

1989 Peugeot 405
1989 Peugeot 405

164 Questions

2006 Peugeot 405
2006 Peugeot 405

161 Questions

Top Peugeot Experts

xxxxxx xxx

Level 3 Expert

5117 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...