1989 Peugeot 405 "three terminal horn relay wiring" Questions

Three: Connect a fused jumper from relay connector terminal 30 to terminal 86. If the horn does not sound, go to Four. If the horns sound, replace the horn relay. Four: Disconnect the the suspect horn

...three major part of the horn is the relay, harness & horn pad, and horn itself.Check the relay if it is functioning by replacing it with similar type ( if you have the spare or a similar relay in ...

...horn and any others ideas please. dave Three things to check here... First find the actual horn assembly... generally under or near the front bumper or radiator support... pull off the wire and check ...

...three (3) possibilities for a continuous blowing of horn: 1. defective/shorted horn relay ( very unlikely); 2. defective/shorted horn switch (very likely); and/or 3. shorted/grounded wiring (likely). ...

...three pins it is probably a hall effect sensor with one pin at reference voltage (5 volts), one pin at ground and the third with a a DC voltage in region of 0.5 to 1.5 volts. The other code, P0529, ...

...three days ago, started fine. And it appears the nothing works. Checked the battery it's hold its' charge. Is the cause a relay or somethig simple, or something more serious? Please check all ...

...terminal connector dangling from the same wire bundle as the brake pedal switch connector.) Buckle the driver's seat belt (avoids nuisance beeps). Now turn the ignition switch to on. After about 5 ...

...three conditions that will cause the computer to activate the fuel-pump half of the main relay: When the key is turned on, the computer will run the fuel pump for two seconds. When the starter is ...

...three most common factors: There are 3 most common reasons for the battery to drain. You have to check these one by one. A bad charging system. Start the engine, and with a multimeter, or Volt/ Ohm ...

...three most common factors: There are 3 most common reasons for the battery to drain. You have to check these one by one. 1 - bad battery: Wit engine OFF, check the voltage between the (+) and (-) ...