...206 NEW clutch pressure and clutch plates were replaced including the bearing. Clutch is making a rattling noise but not when pedal is down. Having difficulty getting into 1st and 2nd gears. Mechanic ...
...206 1.1 petrol 2003. Thanks in advance It seems like the clutch pressure plate has given in. Best would be to replace the clutch pro-kit.( Clutch pressure plate, clutch plate and release
...206 engine cuts out when hot 2003 model petrol runs ok when cold but when in traffic gets hot and cuts out when i leave to cool down starts ok REPLACE THE FAN CLUTCH AND BLADES, BE FINE, ALSO CHANGE ...
Question about Isuzu Cars & Trucks
...replace the clutch and pressure plate. so say my clutch slips easy to tell, engine RPM goes high car not faster. slip. #1 is the clutch cable, go that ignoring service, on all cable cars cause the ...
...206 hdi will not pull out.there is no warning showing on dash to say air bags are not working.the belt will retract when it is finaly pulled out but then will not release again. sounds like the ...
206 clutch slipping after i replaced it and gearbox i have just replaced my gearbox and clutch yet my car is still slipping and i have replaced the clutch fork as we the car is starting 2 become a bit
...appers to be milky then you do have a cracked head hope i hepled ricky Hi i had a problem with intermittent lose of power on my 206 and i solved problem by replacing the clutch pedal
Question about Peugeot Liberte
...206. The car will drive normally then it will rev quite high. I then take my foot off the accelerator pedal and put in the clutch and the throttle stays open. I've checked the throttle cable and it ...
Clutch Kit on a Peugeot 206 model is 2005. The car is running but goes into third gear instead of first gear at times. It seems as if the linkages are not pushing far enough. Can I set it? What is the
Question about Peugeot Cars & Trucks
...206 1.9tdci rear axle any ideas welcome 2 unseized the rear axle will be welcome yhxs brian How did you come to the conclusion that rear axle is seized . The reason I ask is axles don't seize ...
194 questions posted
Usually answered in minutes!
451 Questions
103 Questions
80 Questions
66 Questions
56 Questions