2006 Fiat X1/9 "change cam sensor 2" Questions

2 pumps - one that delivers from the tank, and a high pressure pump for the injectors. Make sure that both are delivering properly - you may need to prime the pumps for quite some time if air got into

...change camshaft sensors , i did that , but the car still wont run , it starts and shut's down in 2 sec and sitll has same code , please help me . Thank you OK, you have a code PO341 which means their ...

...change fuel filter, pump, cam sensor and crank sensor still won't run, but will run on ether. Where to go next? 96 T100 (3.4), will only run for 2-3 seconds then quit, change fuel filter, pump, ...

...on, get an emissions code, they told me to change gas cap, did, light stayed out 2 day, came back on, what else could it be, thanks crank shaft sensor or cam sensor crank shaft sensor or cam ...

Change cam sensor & erase codes.( disconnect battery for a minute or so after.) 340 & 1391 refer to cam sensor problem, and all other 300 codes are cylinder misfires that should disappear when

...Cam shaft sensor code, I replaced the cam sensor 2 times, changed the plugs and wires, Changed the PCM, also fixed and replaced vaccum lines, Replaced wires that was damaged from the harness to the ...

...change the cam sensor wire coming thur bellhousing that is not a cam sensor coming out of the bell housing, it is the crank sensor, to remove it remove the 2 13mm bolts that hold the bracket to the ...

...change cam postioning sensor changed 2 sensors now i here engine rattle upon excelaration I also heard this rattle before changing the sensors it is a 2005 Expedition 4 wheel drive 5.4 lt vin ...

...cam sensor, and now change the ECM computer!! It will start but dies right after!! I could not find a ECM for my truck but a junk yard said that one out of a cavalier with a 2.4 would work ,so that ...

...cam sensor, i have changed the coil pack, tried a different PCM, and the auto shutdown relay.. right now i am lost i cannot figure out what is wrong First, check the ECM fuse in the power control ...