1999 Saab 9-5 "blend door calibration" Questions

...than high on the passenger side. Suspected blend door but seems OK up there. Done the calibration (AUTO - OFF) no fault codes. Any ideas? Thank you. the heater inside is thearthy or the line too ...

blend door or control module? 2016 jeep compass my amber light flashes on the defrost knob I have no air when this is happening. When it stops everything works just fine I open the driver's door and I

...blend door a new heater core and still have no heat. it iwll blow hot and then start blowing cold air after about 3-5 seconds. I was told the acuator may need to be callibrated to my computer is this ...

...blend door located on a 2004 trail blazer Does it have manual or automatic climate control ? manual or automatic has two temp blend door actuators - driver side & passenger side . Video's on ...

...blend door cannot reach desired position. possible failure at evaporator assembly or wiring to blend door actuator. E7 - blend door cannot calibrate. possible failure at evaporator assembly or wiring ...

...blend door move during calibration or changing settings? azc fault 42, recirc door ok. driver's blend door motor works when tested with 9v battery sorry not understanding the Azc fault please ...

...blend door I am having the exact same problem. After turning the ignition to off and restarting the vehicle, the A/C works properly again...for a little while. Is it really the actuator or something ...

...blend door is closed all the way towards the back of carinterior arm is not on door or actuator will it adj. it self? When replacing a door actuator you must perform a re-calibration. To do that you ...

...Blend door actuator feedback failure (bad servo) 24: Mode door actuator feedback failure (bad servo) 25: Ambient temp sensor failure 26: ATC In Car thermister failure (ATC only, bad ATC head or ATC ...

...blend door actuator not working properly. replaced actuator, when plugged in before installing actuator runs constantly. Is the problem in the control board or in the dash? Hello: I have bad news for ...