Question about Kia Sedona
MILES AFTER CLEANING FILTER THEN IY DIED RAN OUT OF GAS ALOT AND PUT DIRTYGAS IN TANK FROM DIRTY GAS CAN You may have clogged the injectors. Where you having this problem before you did anything to it
...Put gas in the tank and she ran for about 3 miles. Then started stalling and won't idle. Fuel Filter probably? Thanks fuel pump is burned out from running out of gas, the pump is cooled by the gas it ...
...gas in the cylinder. Or put a "noid" light on the injector connector to see if the injector circuit for that cylinder is working. Noid lights can be bought at a parts store cheaply, just make sure it ...
After putting a full tank of gas in this morning, the check engine lite came on and its sputtering. Why? Is your gas cap on good and tight? If so I tend to think you may have picked up some water.Add ...
and once it was all put back together it won't start. It sounds like it isn't getting any gas. Tried spraying starting fluid into it and it still won't start. Any ideas? Do you have spark
put a leak sealer in and recharge the gas end of story The Kia has a design FAULT with the Air conditioning just below the main cylinder the ally pipe runs left to right in the middle there is a METAL
...gas tank. Disconnect three electrical connectors and two fuel lines. Mark the fuel lines so you are not confused to put in the new one. The electrical conectoers are individually different from each ...
...put gas in the tank, it has to displace the air at the same time. If the air can't escape, the pump senses the additional pressure and shuts off. In rare cases, it can be the pump nozzle type at the ...
Question about Kia Sedona
...put it in gear it almost stalls out unless you goose the gas. Once you give it a burst of gas, it runs fine from then on. But when we are backing out, sometimes it hard to give it alot of gas and ...
Question about Kia Sedona
...put in the gas tank. I have pumped the tank, changed the spark plugs and it just cranks and won't turn over. PLEASE HELP! CRANKING IS TURNING OVER PULL PLUGS AND LET DRY OUT FOR AWHILE THEN TRY AGAIN ...
1,631 questions posted
Usually answered in minutes!
1,036 Questions
969 Questions
705 Questions
468 Questions
212 Questions