...speedometer... The way I isolated the problem was to take out the speedometer gear and hook it to a cordless dril (electric drills might spin it too fast). Turn the ignition to the "on" position, but ...
...cordless power drill and tighten it to tip of the spedo cable have a friend watch watwc the dash then hit the triggerof the drill make sure you have cable spinning in the right direction.if ...
...of dash.Undo cable at trans end.Spin the inner wire with cordless drill,speedo should move,if not replace speedo cable.Some cables u can pull inside wire from trans end,so don't have to mess with ...
cordless drill to see if speedo then works?regards to the spring coming out? this is difficult to determine but maybe due to the over heating? so go through the above steps as the most important issue
...not working...Any suggestions would be appreciated. Take out the speedometer gear and hook it to a cordless dril (electric drills might spin it too fast). Turn the ignition to the "on" position, but ...
cordless drill will work fine. If the motor spins every time and without failing, then the motor is not the problem. If you notice the motor turning and no air coming out the vents, reverse your wires
...cordless drill and spin the chuck onto the valve then put a good amount of compound on it and then seat the valve while spinning it. This will grind into the existing seat and make it new. Keep ...
...cordless drill and a small drill bit. Take it from an expert: So, there is a flap at the end of the keyhole. Position the drill on the keyhole about 2/3 of the way up and drill in about the length of ...
Question about Cars & Trucks
...and/or repaired. Speedo could be tested by removing sender and gear drive and spinning with cordless drill watching that you dont over speed and wreck the head unit. hope you have some ...
1,631 questions posted
Usually answered in minutes!
1,036 Questions
969 Questions
705 Questions
468 Questions
212 Questions