...ignition first attempted-half turn locked it. try the spare key and if still no joy then its a new new steering lock complete and you have to cut it off with a angle grinder and a big hammer and ...
ignition switch (A) after loosening the screw and disconnecting the 6P connector. 4.Remove the steering column shaft (Refer to the ST group). 5.Remove the key warning switch and key illumination lamp
...ignition lock up if my car is turned off and the steering coloumn is turned one way or the other---when i try to start the car the key will not turn in the ignition. the steering wheel has to be ...
Question about Hyundai Sonata
...ignition lock you can reinstall it and contact your local dealership and give them your car's Vin# which is located on title or vehicle registration. And most dealerships can make you a new ignition ...
...lock located? THE TIP OF THE DOOR KEY IS BROKEN OFF AND STUCK IN THE IGNITION I CANNOT REMOVE THE IGNITION CYLINDER BECAUSE I CANNOT TURN TO ACC POSITION. I CAN START THE CAR FROM THE IGNITION SWITCH ...
...IGNITION LOCK CYLINDER OR ANY PART. All it is is over time the oil in the locking mechanism dries and is used by dirt introduced by the key. The tumbler is no longer pins but strips of metal sitting ...
...ignition lock switch pin. Since I couldn't turn the key at all I drilled that pin completely out and was able to remove that ignition lock switch and reseat it into place. It's such a wack assembly ...
Question about Hyundai Sonata
...lock after turning off the ignition...however..the ignition is not stuck and I am able to insert my key and start the ignition I have noticed this problem on various different vehicles...after you ...
Question about Hyundai Sonata
my 2003 sonota's ignition will not turn it is as if it is locked. the ignition on my 2003 hyundia sonota is stuck in off and will not turn to crank the car. what could be causing this problem? Try ...
Question about Hyundai Sonata
ignition locks are coupled to the steering lock so that one can't remove the key unless the lock is engaged. If that doesn't work, I would remove the top plastic shell around the steering assembly and
545 questions posted
Usually answered in minutes!
1,254 Questions
680 Questions
651 Questions
474 Questions
436 Questions