2002 Hyundai Santa Fe "pcm" Questions

...that changes resistance with temperature. Usually a two wire sensor, a 5Volt reference from PCM (Powertrain Control Module) and ground signal to PCM. This is different from a temperature ...

...it would cause this problem. When the engine is cold the o2 sensor does not send a signal to the pcm at which this time the pcm is operating in a closed loop mode until the o2 sensor warms up then ...

what code po741 P0741 "Torque Converter Clutch Solenoid stuck off" If the PCM detects high torque converter slip when the TCC is commanded ON, then DTC P0741 sets. The Powertrain Control Module (PCM) ...

...codes indicate misfire, except p0320. 1. Check IG failure sensor (1) Connect IG failure sensor and PCM connector (2) Engine "ON" (3) Check that RPM meter on instrument panel is operating correctly ...

where is the pcm located on a 2002 hyundai santa fe 2.4l engine Hello The PCM( ECU) is located on the floor center hump, below dash. To excess, remove kick panel to the right of gas pedal. Steve

my hyundai getz 1.5 crdi has a total electrical failure, want could be wrong? the PCM could have went out, might have to order a new 1, or check the wiring and connections to the PCM

...HYUNDAI Description There is a communication line between Powertrain Control Module (PCM) and Electronic Throttle System (ETS) unit. Using this communication line, various data, such

...terminals 1 and 3 of the connector. If that's good, check the continuity of the center wire to the PCM, pin 5. The PCM is under the dash in the center under the control panel. You can do this

...pressure sensor under evap.system test, if fuel tank's vacuum is higher than prescribed threshold, PCM sets P0441. 1. The fuel tank pressure sensor sends a signal (voltage signal) to the PCM ...

...it ? What does it do? How does it go bad? a crank sensor is a magnetic pulse sensor that tells the pcm(computer) how fast the engine is running. it sends an ac voltage to the pcm and that tells the ...