...censor replaced, help please. Why did you replace the Cam Sensor? Was there a DTC P0340 in the ECM (DTC=Diagnostic Trouble Code, ECM=Engine Control Module)? The 2004 Santa Fe came with three ...
need to find ecm on 2002 hyundai santa fe 2.7 Photo of PCM (ecm) location
Question about Hyundai Santa Fe
03 hyundai santa fe blows ecm fuses after car is warm up and you its blows the 20 amp fuses under hood the first ecm fuses on left side of fuses box There is obviously a short circuit somewhere. Best ...
...the "Check Engine" light comes on, there is always a DTC (Diagnostic Trouble Code) stored in the ECM (Engine Control Module). You'll need an OBDII (On-Board-Diagnostics) scanner to retrieve any ...
and P1723. Thank you The TCM can request activation of the MIL lamp Via a communication line to the ECM. This is only a request from TCM to ECM to turn the MIL on. The fault code is stored in the TCM.
...vacuum leak, valve timing, timing belt, crank position sensor, bad plugs, bad ignition wires, ECM failure, Coil failure, wiring, injectors, fuel pump, and the list goes on and on and on. Does ...
...the "Check Engine" light comes on, there is always a DTC (Diagnostic Trouble Code) stored in the ECM (Engine Control Module). You'll need an OBDII (On-Board-Diagnostics) scanner to retrieve any ...
...the "Check Engine" light comes on, there is always a DTC (Diagnostic Trouble Code) stored in the ECM (Engine Control Module). You'll need an OBDII (On-Board-Diagnostics) scanner to retrieve any ...
...body past the air filter. 2 small bolts hold it in place and it has 1 electrical connector. Your ECM (the engine's computer) may need to be reprogrammed after you change this. The dealer can do
...misfire codes (DTC) P030? and P030? Check out the wiring diagram: Problem could be here or at the ECM connection. If not, then the coil pack has gone bad. I put it in the hyundia shop and they said ...
1,612 questions posted
Usually answered in minutes!
1,503 Questions
1,001 Questions
881 Questions
417 Questions
235 Questions