2002 Hyundai Santa Fe "2 cam sensor connector" Questions

...2 volts range on the 'signal' pin. 3 pin socket (Hall effect, magneto - square wave form output). One pin is 'reference' (5volts), one pin is 'ground' and the third pin is 'signal'. A DC voltage ...

...2 cam. Crank sensor is in the front of the bell housing, behing cooling fan, where engine and trans meet. than other 2 sensors are on sides of the cylinder head in both banks by the air filter box. ...

...2 cam sensors. all cam sensors are sensors that measure cam speed and timing. so attach to them. thus the name.... only exception is old engines with distributors. (cmp is here) do the flash codes ...

problems from 1-2. with codes for rich fuel Cam sensor circuit can be wiring, connectors or the cam sensor. What problems shifting ? Will it not go into second at all ? What rich codes are you having

Cam sensor would, when replaced? P0041 is O2 sensor reversal. Check the back 2 O2 sensors on the exhaust pipes. Is it possible someone put the connectors on the wrong sensors? Try swapping them to see

...cam sensor located, and is it 1 or 2 this the alarm that shows while they give my truck an inspection sticker I looked at info for the 5.7L engine. I only saw one cam sensor and it was located below ...

...2 miles the light comes back on and RPMs wont go over 2000. Changed cam sensor but that would be to easy.Problem is still there.Checked wiring harness for cam sensor and computer connections. Any ...

...cam censor on a 2004 nissan maxima There are 2 on this vehicle one on eitherside of engine. Left and right or bank 1 and bank 2 Consider taking it in for correct diagnosis. Loosen the fixing bolt of ...

...cam signal at pcm" what does that mean exactly Hi, the camshaft position sensor signal is not reaching the powertrain control module. This can be a problem with the sensor, the connector, or the ...

CAM SENSOR 1. Turn OFF the ignition. 2. Remove the serpentine drive belt. 3. Disconnect the sensor electrical connector. 4. Remove the power steering pump, if required. 5. Remove the attaching bolt. 6