Question about Hummer H3
...relay is de-energized. Low speed can also be commanded with a scan tool, by commanding Wiper Relay Cmd. ON and OFF. Refer to Scan Tool Output Controls . High Speed Operation In the High position, the ...
...LOW WPR relay and to the windshield wiper motor. Ground is applied at all times to the coil sides of the wiper relays and the windshield wiper motor from G105. • DTC B3717, the BCM detects a low ...
2006 Hummer H3, the low beam headlights are not working, checked fuses, checked relays, all are good, high beams do work, any suggestions Could be a bad ground wire for the low beams and or the hi/lo ...
...low output speed. Di I need to have it replaced (the whole AC system?) There is a HVAC relay and FUSE in the under hood fuse box, have you check both of these? If the blower works on any speed, the ...
...relay through the low beam headlamp relay control circuit. The headlamp relay will illuminate the low beam headlamps. Install a scan tool. Turn ON the ignition, with the engine OFF. With a scan tool, ...
Question about Hummer H3
...does not work at any speed,hi,low and medium, checked the fuse and relay-OK Check underneath behind the glove box,there is a connector with a red input that might be burnt out.it happens with the ...
relay, bad compressor clutch, bad low pressure switch, bad high pressure switch, clogged a/c line ECT.... There is a lot more involved to A/C,s... But I think this would be the fastest and easiest way
LOW. Those are switched by putting the vehicle in Neutral, and pushing the button the dash, waiting till the correct indicator light illuminates and then putting the truck in drive. Based on the above
Question about Hyundai Cars & Trucks
...fuse / relay box.H/LP low 15 amp fuse also Headlamp relay low . Both high an low headlamps not working ? H/LP (high) fuse 15amp plus HEADLAMP RELAY (high) . Should be marked on the inside of the lid
Question about Hummer H3
...(in the fuse block under the hood) try exchanging it with the #45 cooling fan relay and see if your low beam lights work. If they do, the HDM relay (actually solid state module, not a relay) is
1,120 questions posted
Usually answered in minutes!
180 Questions
91 Questions
110 Questions
71 Questions
11 Questions