2002 Daewoo Leganza "distributor cap rotor" Questions

...distributor cap, and rotor (if applicable). Otherwise, check the coils (a.k.a. coil packs). In some cases, the catalytic converter has gone bad. If you smell rotten eggs in the exhaust, your cat ...

...distributor cap is to be replaced, mark the ignition wires for identification and remove them from the distributor cap.Remove any components necessary to access the distributor cap.Completely loosen ...

distributor cap,do u think that the rotor cap is bad Your distributor bushing is bad, causing the distributor to wobble when running. Get it checked out for repair and/or replace the distributor. Take

...DISTRIBUTOR CAP BEFORE REMOVING CAP. SO YOU CAN PUT PLUGS WIRES BACK IN THE ORIGINAL POSITION. WHEN ALL PLUGS WIRES ON DISTRIBUTOR CAP BEEN NUMBER.REMOVE ALL PLUG WIRES ON CAP.THEN REMOVE THE ...

...distributor cap. Loosen distributor cap hold-down screws and remove cap. Mark rotor position for installation reference, then remove rotor. Remove two harness connectors from distributor. Remove two ...

...distributor cap. At the end of the rotor is a curved metal piece. At each spark plug, inside the distributor cap are metal posts that are cut out. When rotor spins inside cap a spark jumps from the ...

...DISTRIBUTOR CAP AND FOUND THE ROTOR MELTED ON THE TOP, REPLACED THE ROTOR IT LASTED 3 DAYS AND SAME PROBLEM METAL TAB ON ROTOR WAS BURNT UP. WHAT COULD BE CAUSING THIS? The rotor is somehow making ...

...distributor cap towards the corroded side with the cap sitting in place on the distributor. This will help move the cap's electrodes closer to the center of the spark-range (as the computer jockeys ...

...distributor cap falls down(still clipped in) trashing cap and rotor both. I've replaced cap and rotor 4 times in the last week, and have been told the hall sensor may need replaced.. If the ...

...cap fits to the distributor housing, make sure you have the new cap, exactly like the old one, both notches at 3 o'clock, for insistance. Reinstall the cap with the notch mating the distributor ...