1999 Lincoln Town Car "injector wires jeep 4" Questions

wires, breaks, etc and repair as needed. If the wiring looks good, you can swap #4 injector with injector from another cylinder, reset the PCM to clear the code and run again to see if problem follows

...Replaced plugs wires distributor and fuel injector to that cylinder. Still not firing. Any ideas? Also good compression Do you have spark on that plug ? And power and ground for that injector

check wiring,, check 12vd on both injector power pins if wiring is ok check for ecu pin at ecu that drives injector 3 and 4 called the pNp pin if dead ecu is toast. (if injector coils read good.. ohms

...injector 4 wires. then pull connector and see if OHMS (resistances) of coil pins' is wrong (try other injector and compare them) 0 ohms shorted infinity is open oil if resistance is not near others, ...

...wires, plugs, even the air filter. What could be wrong You got the ignition cover, what you need to do an cylinder compression test and also check your injector for voltage while engine running hook ...

...jeep grand cherokee with 4.0 motor but then 3 or 4 seconds later the motor shuts down. it does this three or four times then resets the alarm. on most remote start application a wire is installed in ...

...wires, fuel pump, fuel filter Check injector pulse to make sure the computer is commanding the injector on and off. Check that the plug isn't cracked. Check cylinder compression if all ok you may ...

...jeep liberty 3.7 is not getting no gas to cylinder, injector is new, its got fire to the plugs but #2 cylinder is misfiring, we used a test light on injector and injector is not working What kind of ...

...Jeep wrangler.w/ 3.8L 62, 000 miles. Question is, 1and 4 injectors fade out. Starts with all active but they drop off. I have replaced plugs, wires, coil pack. Even had the computer checked out. And ...

...JEEP LIBERTY 3.7 # 2 FUEL INJECTOR WIRE PIN LOCATION TO TEST FOR BAD WIRE I have a 2004 Jeep Liberty with the 3.7 V6 it says that the number 4 injector has an open circuit how do I fix this problem ...