1997 Lincoln Continental "tell lift pump bad" Questions

...trunk? first i would look under the rear of the car and you will see a ride sensor with a little arm this tells the pump when to run either the arm broke came out of adjustment or the sensor is

...lift pump still had 20 to 22 psi so that was wasted money. have also spent 4 hours hunting the engine over with starter and exhaust off trying to install a crank sensor the dealer sold me .... i tell ...

...clogged. newer diesels, have EFI sensors that can be bad. injection pump bad or messed with and fails. engine compression fails. (a test) tank lift pump bad, and more but no engine or year

tell you if you have bad pressure when running. your mechanical lift pump may be starting to give way and not give the injection pump the pressure it needs and when it is running the injection pump is

tell the car that it needs to lower or pump up the system. The idea is that you want the car lower to load passengers and to lift things into and out of the trunk. When these trigger signals reach the

...tell me why? I have a 4.0L, 6 cylinder engine. Am I getting screwed or is this legit? 5.2 hours labor part runs around $112.00 oil pump is in the oil pan. If you can get the oil pan off without ...

...lift off the s) ok it always starts. when put in park, well gee is starts only in park and neutral.? the engine stalls. try stating what engine does good and bad and when. so it idles all day.? but ...

...tell where it is coming from...Also they can leak from the gasket as well...being paper, cork or some have only an o-ring gasket... I would try to put vehicle on a lift if possible to inspect it ...

...tell them to pump again. the pedal is to be pumped three times every times.With pedal pumped start at master lines, open one allow to bleed a little then close and move to next and allow to bleed. if ...

...bad and compressor is not shutting off at correct level and over pumping may be causing it to be loud or the dryer is also a problem and allowing moisture into system. Disconnecting the lride height ...