1996 Lincoln Town Car "heater blend" Questions

...HEATER SIDE. I WAS TOLD THAT IT WAS MY TEMP BLEND MODUAL THAT NEEDS REPLACING. the part u are referring to is the temperature control blend door actuator motor, it is about center of air ducting, in ...

...one to open door at heater core Those look to be blend door codes you could try resetting them, does the heater make a clicking sound? If that is so the blend door actuator is bad and needs

heater does not work, doors open ok but no heat Air Temperature Control Blend Door Failure No Heat or no AC (dependes on where door sticks) In all modern cars there is a tiny DC electric motor driven ...

...heater door clicks all the time when car is running Check the blend door and other actuators. May be disconnected. My 1999 Ford Winstar and my mom's 1998 Meercury Sable experienced the same problem. ...

...heater core and the blend door is housed) when it binds up the blend door motor which is a very small motor with plastic gears ,cannot get the door to the position requested by the driver and ...

a/c will not switch to heat control head bad or blend door in heater case under dash is bad. Blend door motor can be electric or vacuum. Do other modes change?

heater and a/c blend door actuator motor is located behind the center of the dash just below the windshield. The steering column must be detached and lowered and the dash must be removed to access the

blend door is working as seen through hole cut in plenum, coolant is circulating,heater core is not plugged nor calcified, no electrolysis problems, thermostat is good and engine temp is up to normal.

...blend door accuator is sticking and wont properly open airflow door the acuator is located on top of the heater box, most of the time you have to remove the dash, the most common problem is the ...

...heater blend door AC compressor comes on and lines get cold. Interior mechanicals stay on heat. All digital controls show proper indications. I suspect that the blend door is not working. 1996 Town ...