1994 Lincoln Continental "hole punch down position" Questions

...the hole with a hammer and small punch and drive the pin in then you should be able to slide the cylinder out only other way I've done it is to drill the entire cylinder out which is not an easy ...

the punches press them in and pull down on switch. the lock cylinder comes out by starting in lock position and pressing the small pin on its side and rotating cylinder to the on position and pull out

the rear of the ignition switch lock. Putting it back is a case of pushing the same punch in the hole, insert the switch lock cylinder back in, release the punch, and cycle the key to the off position

...Slide the punch pin into the Silverado's access hole on the underside of the steering column under the ignition. Push up on the punch pin while you pull the ignition out of the steering

...by tuning the key to the on position and inserting a pin punch or similar tool 1/8" in diameter into the hole on the underside of the housing, pushing the locking pin in while pulling the switch

...punch out old stud (of course ) install / position new stud into hole - turn lug nut upside down using a lubed washer between hub and nut and slowly tighten w/lug wrench or air impact wrench set to ...

...There is a hole there. You have to use a small punch or screw driver and push down, when the key is in the run position, then pull the cylinder out. Either way, the key has to be in the run

...punch into the lock cylinder release hole and push inward to release the spring-loaded lock retainer. At the same time, pull the lock cylinder out of the column. Fig. Fig. 5: Depress the lock plate ...

Punch to Knock OUT The CENTER PIN of Rivet ALL Of Them. Then You must DRILL out the Middle of the Aluminum Rivet These should be replaced with bolts and locknut's , Drill until heads can be shaved off

...punch or nail and go through that hole and push the release button. The lock assembly can then be pulled out, there's a steel washer down in the hole with a "D" shaped hole in it be careful not to ...