2003 Hyundai Accent "attach mud flaps" Questions

...age of vehicle ? check under the wheel arch along side of fuel filler pipe you will see a hose attached alongside ? make sure this is not kinked or blocked up at its lower end this hose is the ...

...attach the mud flap to it.I would expect a new mud flap set would include the necessary hardware to adapt it to different vehicles. If you've already purchased a new set without any of this ...

...mud flap. It's rubber and is held in place with six 10 mm bolts. There is also an angle bracket attached to this flap in the center that latches to an overhead support, but there are no bolts on ...

...doesn't appear to lay correctly in the wheelwell. Is the plastic splashguard supposed to be attached to the inside or outside of the lip on the fender in the wheelwell? This fender have screw ...

...mud flap. It's rubber and is held in place with six 10 mm bolts. There is also an angle bracket attached to this flap in the center that latches to an overhead support, but there are no bolts on ...

...is a one piece part(positive crankcase ventilation) its located on the valve covers and has a hose attached to it that goes to the air intake hose of the air breather. this is a simple installation. ...

Attach the power sockets.Push the snapped out side edge of the bumper cover back to its framing, the click sounds will confirm its proper attachment now put all the screws back in a same way they were

...mud flap. It's rubber and is held in place with six 10 mm bolts. There is also an angle bracket attached to this flap in the center that latches to an overhead support, but there are no bolts on ...

mud flap and the flap that protects the radiator from road debris.        4 Loosen the belt tensioner bolt by reaching in from the top of the engine with a socket or

...used to remove the 2 nuts (they should be hand tightened) this released the rear side clip that is attached to the plastic bumper cover. Now pull the carpeting back on each side to expose another ...