...A bad connection at the sensor An open in the ground circuit between the ECT Sensor and the PCM A short in the voltage feed between the sensor and the PCM A bad PCM (less likely) A bad ...
...the tcm is connected properly. there is a o/d shift solenoid that is controlled by this device(tcm/pcm). if the wires and module aren't connected properly or, if the tcm/pcm is malfunctioning, it ...
Question about Hyundai Accent
2003 hyundai accent crank but no start, nospark ,nofuel pump op. cranks but no start have it scan to check camshaft sensor and crankshaft sensor.and pcm.all 3 can cause no spark and no fuel problems.
2012 toyota landcruiser fault code p1251 Being a 2012 I'd hope it's still under warranty. P1251 is throttle body issues. Could be dirty, faulty, bad PCM or a reflash needed
cause coil packs not fire no spark crank position sensor is bad. it sends signal to the pcm to send spark
...replacing parts/sensors unless you can VERIFY they are defective! The Powertrain Control Module (PCM) on Hyundai OBD II vehicles (all 1996 and later models) can adjust the engine Air to Fuel (A/F) ...
2007 Hyundai santa fe hard to start after fill ups. could it be the pcm valve. where is it located. your purge valve may be stuck open, inspect and let me know.
...- DPF EGR Sensor Circuit High Voltage Detected The EGR monitor checks the DPFE sensor signal to the PCM for high voltage. The test fails when the average voltage to the PCM goes to a voltage greater ...
2010hyundai accent pcm pcm replacement procedure Hold on ...That should still be under warranty. If it is a PCM fault have the dealer do the work. Being under warranty it would be free and
...If you did then you have a wirning issue or a connector issue or you bought a bad sensor or the PCM could be bad.. Make a full inspection of the wiring and conector all the way from the sensor to ...
707 questions posted
Usually answered in minutes!
1,131 Questions
1,082 Questions
1,047 Questions
500 Questions
255 Questions