1993 Hyundai Elantra "2 crank sensor test" Questions

...2 codes po441 and 335 which do i change first Hi there:DTC P0335 - Crankshaft Position Sensor A Circuit MalfunctionThe crankshaft position sensor (CKP) measures crankshaft location and relays ...

...2: To check for problems with electronically controlled components such as an engine, transmission, ABS brake, or SRS (supplemental restraint system, Air Bag) and the fuses test okay a trouble code ...

...crank censor what should it be You need a scope or a graphing multi-meter to test these sensors. You need to be able to see the wave form pattern to determine if they are working properly. 2 wire ...

...2: ECU is cutting fuel. Pressure good cranking. 2a: ECU is sending error for bad crank/cam sensors, and cuts fuel. 2b: ECU sees rpm or tacho line dead. 2c. ECU sees TPS sensor output as 4v or more ...

crank position sensor on a 1997 astro van ?The sensor is not installed on the van and I do not have access to the van right now. Also, do you know how much this part is worth.Thanks,Frank If you don't

...2 Have you tested ignition module and coil(s)? 3 Have you tested crank/cam sensors? 4 Does it set a code? No spark on newer cars is usually the crank sensor. Older ones, the ignition module, Older ...

...2 cylinder . Not a MAF sensor , would affect just 1 cylinder . Engine mechanical problem ,maybe . Take it to a qualified repair shop , rather then guessing . Not sure if the crank sensor or the cam ...

...2 hours? Have you done any testing? Any applicable trouble codes? How long since a tune-up? When the vehicle stalls do some testing, if the engine is hot, wear gloves. Use a spark tester, check for ...

crank sensors. and many Halls will fail that test too, (a 10,000 ohm pull up stops that) the noid suck big time current. (if your NOID is LED, then yes it works on most HALL sensors and never VR type.

...2 things (maybe both in worse case scenario) CRANK POSTION SENSOR, Or a fuel pump. Honestly I suspect a crank sensor if its the 4 litre engine. But like the poster said check the valve and see if any ...