2003 Saturn L-Series "camshaft install position sensor" Questions

...spacer installed. Spacer on crankshaft timing sensor and camshaft position sensor. Install the sensor until the spacer lightly touches the sensor ring, and tighten the sensor mounting bolt 105

...Install camshaft position sensor housing so that drive gear engagement occurs. Locate camshaft position sensor electrical connector in the pre-removal position. Install hold-down clamp (washer and ...

...Install camshaft position sensor housing so that drive gear engagement occurs when arrow on locator tool is pointed approximately 75 degrees counterclockwise from the rear face of the cylinder block. ...

...Install camshaft position sensor. Tighten sensor mounting screws to 12.9 Nm (115 in. lbs.) torque. - Carefully attach electrical connector to camshaft position sensor. Installation at an angle may ...

...Install or connect the following: Camshaft position sensor. Torque sensor mounting screws to 80 in. Lbs. (9 Nm) Brake booster hose and electrical harness in holders on end of valve cover Electrical ...

...camshaft. Install target magnet in end of camshaft. Tighten mounting screw to 3 Nm (30 in. lbs.) torque. Over torqueing could cause cracks in magnet. If magnet cracks replace it. Install camshaft ...

...Install the camshaft position sensor cap. Install the rotor. Install the distributor cap and wires. The distributor in the 95 Altima contains an optical sensor with slotted disc to output timing ...

...camshaft. Install target magnet in end of camshaft. Tighten mounting screw to 3.6 Nm (32 5 inch lbs.) torque. Over-torquing could cause cracks in magnet. If magnet cracks replace it. Install camshaft ...

Install the camshaft position sensor. Tighten the mounting bolt to 89 in lb (10 Nm). Connect the CMP sensor electrical connector. Install the power steering pump. 3.4L Engine To Remove: Disconnect the

camshaft. Install the target magnet in the end of the camshaft. Tighten the retainer to 30 inch lbs. (3.4 Nm). Install the camshaft position sensor. Tighten the sensor mounting screws to 80 inch lbs.