2002 Porsche 911 "seat back cable release" Questions

...lower the back seat, you should be able to get your hand in far enough to get at the latch. you'll need a flashlight. some cars have a pull cable in the trunk also which would be even easier. good ...

...seat down, look at how it releases. There is a lever that moves back and forth. That locks and unlocks around the latch or striker. Now try the side that doesn't work, If it's clicking at the latch ...

...back should fold down. Ibelieve you will need to remove seat to repair the cable. the bottom seat when lifted pulls on a cable that releases the backs lock to fold down My cable was stretched and ...

...back of seat down.it will not release seat from floor. You can make it release by pulling up on the metal bracket where the cable attaches under the seat at the back in the middle. I had the same ...

...seat back to allow access to the rear seats. the passenger seat seems to have a cable that when the seat back is folded forward it releases the seat to enable it to slide forward and then return to ...

...back of the seat, past a black round plate, where they become top and bottom cables. Push down toward the floor board on the bottom cable (my bottom cable is no longer black coated but rather a bare ...

...back seat down (behind thr driver seat) that back rest wont release and fold down. I can pull the seat up, but the back rest wont come down. I've been using the back seat both in the stowed position ...

...seat back recline? You may have a broken/disconnected release cable from the release handle to the lock mechanism. If there is no pressure on the release handle when you activate it a cable would be ...

back bolts that hold it in place? If it is a manual seat there is cable under the seat that pulls out the lock tabs on the track. You can use plyers to pull the broken cable to release the seat. If it

...cable snapped of handle When pulling handle in boot of q5 to lower seat handle came away from cable seat will not now come back up Use vise grips and grasp wire to release then install new