...wheel wells holding bumper to inner fender, and fender. Then remove screw holding the splash guard to the lower bumper cover. Finally, remove screws holding the bumper cover to the core ...
...wheel. 3. Using the C-Clamp squeeze the caliper so the piston goes back inside the caliper. 4. Using the 9/16 socket undo the 2 bolts that go through a rubber boot. There's one on the top of the ...
...wheel. 3. Using the C-Clamp squeeze the caliper so the piston goes back inside the caliper. 4. Using the 9/16 socket undo the 2 bolts that go through a rubber boot. There's one on the top of the ...
...retaining spring with the pliers. Reconnect the lower and upper return springs, using pliers. Install the brake drum, you may have to squeeze cylinder piston inward a bit to get the drum to start to ...
...wheel. Detach the brake hose from the support bracket. Detach the outer brake pad retaining clip. NOTE: Pull the caliper outwards to release the piston. Detach the caliper. Remove the bolt covers. ...
...wheel liner Remove plastic push pins attaching fascia to liftgate opening Remove screws attaching fascia to liftgate opening. Remove D pillar trim and scuff plate outboard screws. Remove the rearward ...
...wheel and tire assemblies. Disconnect brake hose from caliper. Remove caliper locking bolt. Rotate pad assembly upward then remove pad retaining clip and caliper assembly Remove brake pad support ...
...wheel. Remove the retaining clip at the center of the steering wheel (if equipped) and then remove the mounting nut beneath it. Pay attention to the alignment of the steering wheel locating notch for ...
...wheel and brakes drum off etc. To remove the rear axle to replace a bearing you have to remove the rear differential cover and remove the small retaining bolt holds the spider gear shaft in place and ...
Question about Chevrolet Cars & Trucks
...wheel speed sensor) to the rear edge of the first retaining clip. This distance must not exceed 24.7 cm (9.75 in). If the distance is equal to or greater than 24.7 cm (9.75 in), you must move the ...
456 questions posted
Usually answered in minutes!
685 Questions
635 Questions
542 Questions
457 Questions
284 Questions