torque: 18 ft. lbs. (25 Nm, 2.5 kg-m) Mark cylinder head bolts for rotational reference. Rotate cylinder head bolts 90°(1/4 Turn) in order shown. CAUTION: Do not reuse the old cylinder head bolts
...torque specifications: Crankshaft pulley: 9-13 ft. lbs. (12-17 Nm) Water pump pulley: 9-13 ft. lbs. (12-17 Nm) Connect the negative battery cable. 1.6L (VIN 3) & 2.0L Engines Before servicing the ...
torque: 28 - 38 ft. lbs. (38 - 51 Nm, 3.9 - 5.2 kg-m) 9. Rotate crankshaft two full revolutions (clockwise only) and align timing mark on timing belt pulley with timing mark on engine block. 10. Check
Question about Hyundai Cars & Trucks
...Torque 60 Nm. (44 ft. lbs.) + 1/4 turn (90°) [1] [1] Always replace bolts. CYLINDER HEAD TIGHTENING TORQUE [1] : 1st sequence: 40 Nm (30 ft lb) 2nd sequence: 60 Nm (43 ft lb) Final sequence: plus 1/2 ...
...torque specs on axle nuts for dana 50 rear axle Dana 50 Front Axle Observe the following torques; * Left and Right drive axles-to-cross member: 120-150 ft. lbs. (163-203 Nm) * Axle arm-to-radius arm: ...
Question about Plymouth Cars & Trucks
...Nm) Torque bolts No. 1 through 6 to 110 ft. lbs. (149 Nm) Torque bolt No. 7 to 100 ft. lbs. (136 Nm) Torque bolts No. 8 through 10 to 110 ft. lbs. (149 Nm) Re-tighten each bolt to its proper torque. ...
Nm). Using a torque angle meter turn the bolts 90 degrees in the proper sequence. Left side exhaust manifold. Torque the bolts to 12 ft. lbs. (16 Nm). Spark plugs. Torque the plugs 11 ft. lbs. (15 Nm)
...Nm (22 ft. lbs.) torque. Tighten all bolts in sequence (1 through 14) to 61 Nm (45 ft. lbs.) torque. Check all bolts to verify they are set to 61 Nm (45 ft. lbs.) torque. Tighten bolts in sequence: ...
Nm). Using a torque angle meter turn the bolts 90 degrees in the proper sequence. Left side exhaust manifold. Torque the bolts to 12 ft. lbs. (16 Nm). Spark plugs. Torque the plugs 11 ft. lbs. (15 Nm)
Question about Cars & Trucks
...torque: 30 Nm (22 ft-lbs) + 90 degrees + 90 degrees (in 3 steps of 90 degrees each) Main bearing cap bolts torque: 30 Nm (22 ft-lbs) + 90 degrees Connecting rod bolts torque: 25 Nm (18 ft-lbs) + 90 ...
456 questions posted
Usually answered in minutes!
685 Questions
635 Questions
542 Questions
457 Questions
284 Questions