1994 Kia Sephia "front hub press" Questions

hub from front axle? Splines are binding, I've applied a puller, ball and tie rod ends removed and strut to knuckle bolts are loosened. I need to replace the outer CV joint. Any advice is appreciated,

front wheel bearings on a 1994 Kia Sephia? its a pressed in bearing,i would recommend u to have it done by mec.but here goes,take wheel off,undo cv axle center bolt,undo brakes,calyper,disc rotor,undo

...in front Knock the old one out with a hammer, and pull the new one back in with the lugnut, put on 'backwards'. This way the flat part of the nut is pressing against the hub, to pull the stud

...front hub/steering knuckle assembly from vehicle. Position front hub/steering knuckle assembly on a press and press front hub out of steering knuckle using a suitable removal tool. Remove E-clip from ...

...front axle hub nut. Disconnect the front stabilizer link from the strut. Disconnect the speed sensor (with ABS). Remove the front brake caliper and rotor. Disconnect the tie rod end. Remove mounting ...

...front wheel bearing is pressed into hub and has retaining clip on rear and then cv axle shaft comes through center and has a nut and keeper pin. Rule of thumb is to replace both front wheel bearings ...

...front wheel hub from the knuckle assembly. Remove or disconnect the following: Bearing inner race from the front wheel hub Retaining ring from within the knuckle Front wheel bearing from the knuckle, ...

...front hub? In order to change them you must do the following. 1) Remove tire 2) decompress the brake caliper 3) unbolt brake caliper and lay it to the side (no need to disconnect brake line 4) remove ...

...front hub to replace the studs. How do you remove the front hub? i belive you need to loossen the 4 botlst in the back if they are not there then the hub assembly is pressed on and will need a hub ...

...HUB BEARING Front Is pressed into hub & knuckle.Rear is a Hub/Bearing Assembly held in by 4 10mm bolts.Will need to pound out with hammer in rear after bolts come out,lots of rust holding them ...