...cylinder head cover. Detach accelerator cable and place off to side. Remove the following; Air hose Air ISC air hose Breather hose Vacuum hose from air intake hose Disconnect mass air flow sensor ...
...Cylinder head cover Cylinder head with the intake and exhaust manifolds attached 3 wire harness connectors at the rear of the cylinder head To install: Fig. Cylinder head removal sequence Place the ...
cylinder head bolt 4 cylinder KIA sportage torque settig cylinder head bolt 4 cylinder KIA sportage I need the torque settings and pattern for a Kia Sportage 2.2 im after the torque settings for a kia
...cylinder head cover using the ratchet and socket. There are six bolts. Remove the cylinder head cover. There are four bolts and two coils. Twist the boot on the high tension leads attached to each ...
...cylinder heads the head bolt tension is not as it should be. This comes from mainly 2 items . one is that the head is warped and is not tightening evenly and two the head stud holes are full of water ...
torque on cylinder head bolts/2.o engine hello where can I get some bolts for a 1996 kia sportage 2.0 dohc 1998cc fe 1995-02
Cylinder head torque settings typically 33 ft. lbs plus 90 degree turn. But read the box of the new bolts. AND yes... replace the bolts
...cylinder head decked check for warpage.you might need valve job if valves look worn machine shop will check cylinder head for cracks.when you do a head gasket replacement it more to it than replace ...
cylinder head tightening sequence on 1997 kia sportage how to tension head Cylinder head bolt 62 ft-lb. (84N.m) starting with the two in the center, then the two forward of the center, then the two ...
...cylinder head alloy head petrol then its about 80lbs .diesel around 90 to a 100 not sure their as i just pull any head bolt down till i feel the bolt stretch but i wouldnt advise anyone to do it my ...
153 questions posted
Usually answered in minutes!
1,074 Questions
1,058 Questions
918 Questions
753 Questions
343 Questions