1995 Saab 900 "seat cover" Questions

...covers need to be removed and the element replaced. For an illustrated tutorial on how to remove the bottom seat cover, go here and select the entry labeled: 18.12.2004: NG 900: Front Seat

...cover that actually fits a 1995 900 for cheap, or replace just the bottom cushions? Neoprene two tone seat covers are available at State of Nine but are pricey. You can spend about $250 and perform a ...

...cover and undo two console hold down screws (Torx 25) in front of the shift lever; there are two more in the aperture remaining when you take out the rear ashtray. Turn on the ignition key so you can ...

...seat forward Remove plastic cover (6 plastic clips) Remove bolts (8or9) holding motor cover Lift front of cover up (motor should be upright at this point) There is a line on the white plastic ...

cover are chirping and beeping intermittently. Owners manual does not say what they are for. What are they for and what do I do to fix. Here is a wiring dig on ur setbelts I am Somewhat sure it is for

...the pump with a test light (under the back seat, under the flap of carpet, under the black plastic cover). If you have power there, the pumps bad. If you don't check all the fuses realted to the

...cover off the console (it might be a tight fit as it is stretched onto it's retaining grip) and spray WD40 into a small hole in the gear shift seat that you will find ahead of the gear shifter, using ...

seat backrest. Remove the plastic trim - held on by 4 screws and 2 pop out plastic cllips. Undo the 8 large bolts that hold the cover in place - 2 on top and 3 on front and back.Then lift up the cover

seat....Gap in cover near window right ? Unhitch the cover on the passenger side rear near gas tank and inside you'll see the convertible motor. The rear level disengages the motor so you can move

...cover lift open then get out the car and look around to see for fluid residue.. if not and there are no leaks.. possible the seals in the pump it self has gone out.. and the motor is still trying to ...