1999 Land Rover Discovery "kick starter bolt" Questions

...starter maount bolt it cranks but still kicks back and will not start The timing is out . you can check this by getting #1 to TDC, pull the cap off and see where the rotor is pointing. It should be ...

...kick starter has stopped engaging. Kick starter made a snap noise, and now won't engage. You posted to the category 'Cars and Trucks'. You have a car that needs kick starting, like an old Heinkel, ...

starter kick back Okay help please.We have a 99 yukon when it rains or we wash it it goes nuts!!will run fine than will start to shake,bog down ,like no power,hit gas and it shutters and chugs a bit ...

...starter on my 2004 grand am 3400 REMOVE ENGINE DAMPER, DISCON BATTERY, JACK CAR UP, REMOVE BOLTS, REMOVE WIRES, THROW DEAD STARTER IN LAWN AND KICK, REPLACE STARTER IN

vehicle wont kick over just winds if starter just wind look for loose or missing starter bolt.or starter drive pinion broken or gear worn or flywheel has worn damaged gear teeth.

...starter gear kick out to catch ur flex plate which turns the engine over it sounds like the drive gear on the starter is not kicking out as far as fixing it it is a farly simple job a few bolts and ...

...starter. It should kick out and spin gear. The bolts are 15 mm. The bottom one is in a tight space where your rachet and socket will unscrew it, but then the rachet will be trapped by the bolt head, ...

...enguage. Have you chk. the starter switch on the steering colume under dash? Or is starter drive kicking in but not engaging teeth in flexplate? If its not engaging teeth on flexplate starter

...(though it's easier to mount the starter then connect wiring). Just make sure you disconnect the negative battery terminal so as to not allow the starter to kick over the engine while you're

starter still won't crank, try shorting the two bolt terminals on the solenoid (carefull, it will spark). If the starter cranks then it's okay, suspect solenoid.If the solenoid is okay you should hear