2000 Lincoln Town Car "abs sensor cause misfiring" Questions

...SENSOR NOT OPERATING PROPERLY OR BENT OR MISSING EXCITER RING ON FRONT HUB OR REAR AXLE. EITHER WAY THERE IS AN ABS FAULT OR A DIFFERENCE IN WHEELSPEED ON ONE OF THE FOUR WHEELS CAUSING TRAC LIGHT TO ...

abs sensor going bad.  There is alot of things that could cause a misfire,mass air flow sensor could be dirty or need replaced.Best bet is to take to someone with computer that can read

codes P306 which is a misfire in cylinder 6. Check. U2108 and U2107 and P0828. Understand what lost ABS/TCS control system and lost communication with body control module. Any repair suggestions check

...ABS light the easiest thing to check or replace is the speed sensor on the wheel. Because this is a magnetic pick-up sensor and due to the location (on the wheel behind the rotor) can be susceptible ...

...sensor or at the least fuel pump or filter.. Havent read it lately but the error codes I got one time with the jumper and lights blinking was engine 25, abs 54, and height 52,73. All of which I can't ...

sensor / ABS sensor is bad, so its causing ABS to shut down. (although, i think my ABS would turn on EVERY time i lightly stepped on the brakes before the light came on.. it was dumb.) Sooo that could

...sensor code replaced it then it said misfire cylinder 4 and replaced plugs and wires and now it says misfire in engine at one point in between it said it had canister purge issues and it has both ...

...sensor data while the vehicle is in motion. Replace any faulty wheel speed sensors. Check ABS Pump: Inspect the ABS pump for any signs of damage or malfunction. Ensure that it is receiving proper ...

...ABS sensor on the wheel. He hooked it up to the computer and that is the code it gave him. I just don't have the money to fix it right now. The mechanic said it would be about 150 bucks or so to fix. ...

damaged....That's what is causing the ABS light....The wire going to the sensor may be pinched or unplugged.....Look for sensor mount bent or damaged...Must have .018 air gap to read inductor ring....