...remove the crank shat pulley in a 2004 Kia Rio? use a nice snap on breaker bar--- correct socket on bottom pulley bolt ,wedge bar into suspension the turn starter and the starter motor will crack the ...
...remove the whole shaft just spread the clip and tap with a copper hammer.wash the thing out with diesel and take the balls out and give it a good clean ,rebuild and pack with grease slide the new ...
Question about Kia Rio
...big job just take the suspension unit off and remove the shaft and then the sensor and then hook the toothed gear out and fit a new one then refit the shaft and suspension and refill the gearbox ...
...remove them, the castle nut is next (looks like a little castle turret), washers, a lock nut and then finally the bearings are next. Clean out the aperture with a clean cloth. Regrease the bearings ...
Question about BMW Cars & Trucks
...remove bmw z3 rear alloy wheel, have removed all 5 wheel studs but wheel still will not budge, thanks Tony the alloy wheel has siezed on the hub spiggot use a lever or something on the suspension ...
remove the wheel of course ,sorry getting tired in this time zone ,right now put a big pair of stilsons on the drive shaft so it cannot pull out from the inner end then tap the end with a heavy hammer
...Refit the calipers to the mounts and re-tension the bolts very tight. pump the brake pedal several times to take up the adjustment and then bleed the brakes to remove any air in the system. Any ...
remove track rod end. unscrew the large centre hub nut that you slackened off when on the ground, pull the hub towards you - might have to gently tap drive shaft through the hub using a soft hammer or
1994 Jaguar XJR 4.0 (Six Cylinder) I wish to check the tightness of the rear suspension top mounts and it looks like the rear seat might need to come out in order to reach them. If so, can you advise ...
...remove the bolts which hold the clutch cover (pressure plate) that is what holds in the clutch plate. Did I mention that this is not an easy job? It would be advisable to replace the pressure plate, ...
844 questions posted
Usually answered in minutes!
685 Questions
635 Questions
457 Questions
277 Questions
284 Questions
