...rear drum to get to the stud. Loosen the remaining lug nuts, then jack up the car, take off the wheel, and ease off the brake drum. Whack the end of the stud to start it out of the hole, then take a ...
Question about Kia Rio
...rear wheel bearings on a 2004 Kia Rio? Most of the replies on the net so far (for others) have either been facetious or just plain rude. These use a lock nut and notched thrust washer to hold the ...
rear hub u have a inner and outter bearing ..change bearing dont forget to pack new bearing well with a GAA Bearing Grease...and install wheel and tighten middle nut till wheel is tight...then back it
Question about Kia Rio
rear brake anti-lock sensor indicator . Tighten retaining bolt to 4.5-6.8 Nm (40-60 lb-in). Install rear disc brake caliper and rear disc brake rotor . Install wheels and tires. ----------------------
rear bearings an a KIA Sadona 2004 van not bad to do remove cap over hub remove lock nt whole hb should come off replace seals and new races for new bearings when tighting back up nut tighten slightly
...rear wheel bearings on a 2004 chevy express 1500 van? Axle Shaft Bearing & SealRemoval & InstallationTo Remove: Raise and safely support the vehicle. Remove the axle shaft. If replacing only ...
...Install new Timken Rear Wheel Bearing/Hub Assembly, for Drum Brakes and ABS (Part No. 512162). Tighten new axle spindle nut (Dorman 05114) 221 lb.-ft., replace grease cap, and button everything
...tighten the pinion nut to the proper torque specification. Reinstall the rear cover and refill the differential with the recommended gear oil. Reinstall the driveshaft, making sure to properly align ...
Question about Kia Rio
rear wheel hub complete with bearings. The old bearing hub nut was not that tight coming off the stub shaft and was fitted with thread locker. I have seen figures of 280Nm right down to tightening the
...rear wheels that increase with vehicle speed. It stops during left hand turns then return when going straight. No change to noise when turning right. I think it may be wheel bearing. How do you ...
973 questions posted
Usually answered in minutes!
685 Questions
542 Questions
457 Questions
277 Questions
284 Questions