2003 Kia Rio "1 head gasket" Questions

...other problems. If you do a compression check and have compression on all cylinders but extremely high compression on 1 or 2 then the problem is the Head gasket, head or Cylinder wall being

...1/4 turn tighterwhat is the point? you have to do it this way so that the bolts dont lift or back out of the head and then the new gasket will blow the gasket again as if you never did the job. You ...

...1 .i change MAF senor and intake manifold gaskit still the same now what to do ? How many miles, and have you had the fuel filter changed at all? It could also be an O2 sensor. Try removing them. Tip ...

...head gasket from 1 van to the other You don't, not the head gasket anyway. You should always replace the gasket with a new one. You can use a cylinder head off one vehicle for another as long as it's ...

1. Cylinder head cover. 1) Install the cylinder head cover gasket to cylinder head cover. 3) Apply liquid gasket (TB1207B or equivalent) to the rubber seal of the camshaft end, injector harness gasket

...1 The head gasket is in between the cylinder head and the engine block. The sly has a single overhead cam engine. This head is know for being porus and allowing oil into the coolant. If this is the ...

...1: Loosen and remove the cylinder head cover retaining nuts Disconnect the PCV hose. Remove the six nuts and seal washers from the cylinder head cover. Loosen them in a crisscross pattern. Remove the ...

...1 session in head gasket blew again. WHY !! Please help Did you have the flatness of the block deck checked? Same thing for the head flatness. If one or both are not flat, then you will continue ...

...head gasket with no of notch 0 or 1 or 2 or 3 or 4 vary and similarly which material is better for head gasket plz help m in a jeoperdy unless you have had extensive head work the I suggest that you ...

...head gasket removed,
may be used.
MEASURING PISTON PROTRUSION
(1) Use special tool VM.1010 with dial indicator
special tool VM.1013 (Fig. 66).
(2) Bring the piston of cylinder no. 1 ...