2000 Kia Sephia "thrust master" Questions

master cylinder is been leaking or either completely empty of (brake fluid used for the clutch) or the clutch pipe has burst (wo'nt HOLD ANY PRESSURE). the thrust bearing has gone through the diaphram

...engaging, thrust rod not retracting hydraulic clutch --replace the clutch master cylinder as the compensating port is blocked if cable replace the cable as it is breaking and jamming in the outer ...

...won't operate. Replaced Slave Cylinder what does it do? might be the master cylinder, thrust bearing, plate, disk, fork ....please add detail of how the non operation is evidenced and repost the ...

...master if it drops it's still good. do same gain and watch the slave if it extends and moves the lever it's still good, last one should mean your thrust bearing is rooted and needs replacing, ...

master cylinder yesterday and this morning, there is no pedal again. Any ideas? Hi most chevy"s are fitted with a concentric slave thrust bearing. This normally creates hydraulic fluid leakage between

...in gears? The gear shifting is locked in gear, cannot go into gears? check the master cylinder the seals may be gone .if so get the seals online.or it is your clutch fork.not on your thrust

...this would point to a leak ( damaged rubber seals or slave or master cylinder rubbers leak ) or air bubble , or low fluid level not actuating the thrust arm properly hope this is of help regards ...

...grinds everytime just replace master cylinder and bypassed clutch damper what so i do ? Remove gearbox and replace the whole clutch assemberly.Problem is your thrust bearing as collapsed.Good

...thrust bearing.what could be the problem???? I would think you have a hydraulic clutch, so there should be a return spring on the pedal or the master cylinder. if your clutch is hydraulic must bleeb ...

...disk, pressure plate, thrust bearing, throwout bearing, and in your case since its a Ford/Mazda the slave cylinder and plastic line to the master cylinder. A very big job for the