Question about GMC Cars & Trucks
...Install the NEW spark plugs. Tighten: Tighten the spark plugs for a USED cylinder head to 15 [n-m] (11 lb ft). Tighten the spark plugs for the initial installation of a NEW cylinder head to 30 [n-m] ...
...Install a new cylinder head gasket onto the cylinder head assembly. Apply sealant to the gasket and do not reuse the old cylinder head gasket. 3. Install the cylinder head bolts. Starting at top ...
Question about Mercury Cars & Trucks
...install, noting following: a. Clean cylinder head intake manifold, valve cover and cylinder head gasket surfaces. Ensure flatness of cylinder head and cylinder block gasket surfaces meets ...
Question about Cadillac Cars & Trucks
...Install the cylinder head with a new gasket. Lubricate the bolts with engine oil prior to installation. Torque the M11 bolts in sequence as follows: Step 1: 30 ft. lbs. (40 Nm), plus an additional 70 ...
new valve cover gasket (6584) on cylinder head and install retaining bolts. Note location of ignition wire routing clip stud bolts. Tighten retaining bolts to 9-12 Nm (7-9 lb-ft). Install upper intake
Install the cylinder heads with new gaskets. Do not apply sealant to these surfaces. Tighten the bolts in sequence to 75?82 ft. lbs. (105?115 Nm). Installation is the reverse of the removal procedure.
...new thermostat; replaced all coils and spark plugs and breather elbows; ... The 12-cylinder engine is a hot-running engine to begin with, so if you've changed thermostats, did you install one that ...
...@ 114mph now 12:90's @ 107mph. Head gaskets are new as well. Motor does not smoke or burn oil or foul plugs. Can you help me find an answer to this problem? MORE THAN LIKELY BROKEN RING ON A ...
...bolts, clean the mating surface, install new gasket, and reattach the valve cover with the bolts. You may need to remove the following spark plug wires vacuum lines air cleaner assembly oil filler ...
...Install the cylinder heads. Use new gaskets and tighten the bolts, in sequence, as follows:Step 1: Bolts 1-8 to 20 ft. lbs. (27 Nm)Step 2: Bolts 1-10 verify torque without looseningStep 3: Bolts 9-12 ...
1,120 questions posted
Usually answered in minutes!
1,706 Questions
907 Questions
348 Questions
103 Questions
32 Questions