1991 Jaguar XJ6 "transmission fault light" Questions

1990 jag transmission fault light comes on.engine breaks down under load change the tps sensor it should be fine

transmission fault code came on and engine quit. Cranks over fine but will not start. Ran perfect before that. One possible problem that is quite common with these cars is a bad crank position sensor.

transmission. It doesnt start. Went to work,worked just fine. Dead later on the same day. Battery ok. Tried jerking the gear stick...Nothing. Checked the Inertia switch...ok. Checked for power at fuse

...fault might be have the transmission tested for electronic fault codes that are stored when this OD light flashes, many times this code will be for a transmission slipping issue, u will not fell this ...

...transmission fault in the trans controller. It could be as simple as an input speed sensor or as complexed as an internal failure. Either way have the transmission fault codes checked for a proper ...

...has a transmission problem? mostly it will be the engine light as it reads engine and transmission faults. If there is a doubt then run the fault codes and check for any transmission recorded

...fault in engine driveability or performance, transmission control system or transmission, or the emissions system, and a fault code is set and stored in the computer. Faults that can set the check ...

...fault has occurred in the transmission or the electronic control sensors and actuators. You need the dealer to scan the transmission control module (TCM) to see what fault code is stored and then ...

...transmission is in the fail safe mode, accelerate gently and keep the road speed lower than full highway speed.Earlier models do not employ fault codes and must be diagnosed manually. Late models do ...

gear The light is flashing to alert you to the fact that the transmission control module has detected a fault in the operation of the transmission. You now need that fault ID-ed by a shop and repaired