2004 Hyundai Elantra "brake light sand signal lights" Questions

...brake lights are not coming on regularly. sometimes they all light up but most times they do not. All fuses have been checked...what else can be done? Look at the brake switch. located just above the ...

brake is applied then signals don't flash. Usually applying brakes when turning so not good Check all earth wires on all lights. most lights in cars run in series so if u loose one you loose the other

...brake pedal. Using sand paper, I cleaned up these contacts and put an ohm-meter to confirm the switch is working. Also, I have a wiring ribbon cable coming out of the sterring column (presumably for ...

...brake light over rear window works. just look for the blackened/burned pin on the rear light plastic connector and sand it down to re-establish a good electrical connection and save yourself $800 big ...

...brake and headlights work.the right headlight comes on sometime.my interior and other exterior lights do not come on at all.....please help.......thank you try checking all the grounds use sand paper ...

...light for the brake warning light and a seperate warning light for the battery. As you say when you apply the brakes or signal these lights come back on then it is going to be a voltage problem it ...

...brake light doesn't, you probably need a new turn signal switch. This is inside the steering column behind the steering wheel. You have to remove the steering wheel to get to it. The brake lights are ...

brake light circuit from amperage overload. If the fuse has failed it will not allow the electrical current to continue to the brake lights. To check the fuse, first locate the brake light system fuse

...light assembly as if you are going to replace the bulbs? Usually a push in, quarter turn to pull the bulb out, then inspect the inside socket. Use sand paper then paper towel to remove it. Some folks ...

brake light. i have replaced all three bulbs twice, checked and cleaned the connectors, removed the ground, sanded the chasis and reconnected the ground. the fuses are checked and are fine, I have now