2001 Hyundai Sonata "changing crank" Questions

cranks but wont turn over I have 2000 Hyundai Sonata of course. It broke down when i was driving on a road trip. It suddenly lost power and after that wouldnt even crank. I got it towed and the ...

how do i get the engine to not move so i can remove the crank pully trying to change the timing belt and the crank is stuck can't get the engine to stop moving so i can remove the bolt holding the ...

...changing crank sensor belt was not broke. there could be to problems same happend to me 1.you might have a problem with your alternator go get it checked at auto zone or something 2.theres a magnet ...

crank sensor???? I have a 2000 hyundai sonata. I had a code for a bad crank sensor. the car would stop running here and there. I replaced the crank sensor and now the car won't start at all, and there

Is it possible to get a diagram of the crank sensor for the 2004 hyundai sonata well what are you looking for exactly it is located under the harmonic balancer pully you must pull the pully off the ...

1999 hyundhi no start 1999 hyundi sonata v6 changed the coils ,new alt.,runs great but when it gets hot ,when you shut it off it won't start lots of crank but no spark.someone told me it could be the ...

2005 Hyundai Sonata cranks, no spark 2005 Hyundai Sonata just died while on the freeway (battery completely dead) with new battery in just cranks, no spark. usually the distributor MODULE they are ...

...crank sensors,were they even tested, how,and were they bad? Have an oscilloscope put on the fuel pump, it may be binding and starting to fail Also,why do you feel cooling off has anything to do with ...

i change the crank position sensor and now get the code 443 and 161 and i can't erased and a won't start P0433....Heated Catalyst Efficiency Below Threshold (Bank 2) P0161....O2 Sensor Heater Circuit

2000 sonata crank sensor I have a 2000 sonata that died and when scanned gave code p0335. I went to change the sensor and noticed the balance shaft belt was snapped so I changed it then put the new ...