Question about Land Rover Freelander
...my stering wheel 2 things to consider Brake pads are worn out and base plates scraping against the rotors or almost worn out and warning metal plate called a sqealer is contacting the rotor as a ...
hi i have a spark from coil to distributer cap but cant get spark at any of my plugs changed all plugs and cap and rotary arm even tried crank sensor but still wont start?any ideas w reg 1.8 petrol ...
Squeaking brake from the front ( one side) I replaced the whole set ( front rotors and pads ), but the squeaking noise comes from the right from side when I depress the brake.Will reassembly or new ...
Question about Land Rover Freelander
98 freelander , runs fine from cold when under load cuts out , the car will start again after few mins , sometimes , misfires , changed dissy cap , rotor arm, ignition coil pack, and mechanic on just ...
i have a 1998 freelander 1.8 i have a good spark i have petrol i have compression if i pull it it will start and keep running so long as i keep it reving but even when warm it will not start fitted ...
...You will need some anti seizing compound and some high temp grease to do the job right. Check the rotors, if glazed or smooth, have them turned at any maching shop or brake place. When using the c ...
2003 sierra rear brake rotors what is max and min thickness (discard) spec on 03 gmc rear rotors & why when replacing pads on rear, is the inboard pad so tight to fit into caliper? my next step is to ...
avalanche minimum rotor thickness What is the min. rear rotor thickness for a 2002 Avalanche Z-71 (1500, 4WD)? Rear Brakes JC5/JH5 Utility Only Rotor Discard Thickness* .............................. ...
need to replace rotor/hub assembly on 08 f150 08 f150 4.6 i have rotor/hub assembly on truck when rotors are bad they cant be turn because its a one piece rotor and hub together cant i just separate ...
how do i remove old rotor to replace with a new one brake rotor or distributor rotor? The brake rotor usually gets rusted on....putting a hammer on one portion of the rotor face and striking the rotor
624 questions posted
Usually answered in minutes!
931 Questions
319 Questions
132 Questions
68 Questions
26 Questions